What To Spray On Vinyl Stickers To Position Before Drying

In dry applications if the graphic touches the substrate before you have it in a set position then you have to snap it back up.

What to spray on vinyl stickers to position before drying. Use squeegee to remove fluid using a good deal of pressure and working from the center out to the edges in all directions. You want to make sure that your vinyl adheres well and that nothing comes up with the transfer paper. Many clear coat paints will remove or tarnish and smear printed decals. 3 backing paper the bottom.

Peel the decal with the transfer masking tape up off of the paper backing. Apply water to the back side of the decal. Spray surface again with rapid tac peel backing off decal and place on wet surface. Firmly place the decal.

Without wetting solutions the vinyl is a little more difficult to handle because it is sticky. I used a heat gun to ease the decal around corners and was able to work the decal for at least 15 minutes. Clean the vehicles surface with a degreaser such as liquid dish soap or rubbing alcohol to remove the wax before you begin. This should help the decal adhere to the surface of the vehicle better and it also allows you to slide the decal into its final position.

My cleaner of choice is to fill a spray bottle with 1 2 isopropyl alcohol 1 2 water. You can go ahead and paint it or spray paint it but just be sure to give it a really long time to dry before applying the vinyl. Pulling the decal nice and tight apply it to the surface using a helper for larger decals. The soapy water allows you to slide decal into place.

Tend to the transfer tape many of our stickers come with three layers. Perhaps the most compelling advantage of wet applications is the ability to reposition the graphic with ease. Saturate paper cover tape if any with rapid tac then remove paper tape. But always test a sample of your clear paint with a sample decal first.

Rim caps or tiny applications or your decals have fine details such as a die cut vinyl decal that might otherwise catch on it s sharp corners. Rapid tac application fluid s best feature is that it effectively breaks the surface tension of the adhesive on the film allowing it to flow and bond to the substrate more effectively than even a dry application. Step 2 spray surface again with rapid tac peel backing off decal and place on wet surface. A clear coat or several can add pristine uniform gloss.

The soapy water will dry in a few minutes and leave your sticker firmly affixed. The vinyl has a tendency to want to lift up if you don t have a surface that s perfectly smooth. If you have any wax or polish on the car your vinyl will be sticking to the wax instead of the car. While the area is still very wet place the decal in selected position.

1 transfer tape the clear top layer that clings to the non adhesive side of the sticker and holds the sticker together. It then helps to float the vinyl film until it is properly positioned.